Magic Wand 4C 4D Transponder chip generator comes out, which not only generate 4D63, 83 40bit and 83 80bit chip but also is used to generate 4C chips original 4D70 blank Chip to 4D small capacity chips. Well, there is a detailed introduction of Magic Wand.
What is Magic Wand 4C 4D?
Power supply: Above 5v 1.5a usb charger, please charge the Magic Wand using
Android phone USB cable.
PS: You had better not use the sub-standard power supply because it will influence the function of magic wand ,leading to the magic WAND’s wrong.
Ford/Mazda immobilizer chips are 3 types available:
1. 4D63 (40bit/DST40) small capacity.
2. 83 (40bit/ DST40) small capacity.
3. 83 (80bit/DST80) big capacity.
a usages description of key button
This button is used for reading chip. After you put the chip into the slot, press “Read” button and get the reading result. If it doesn’t succeed to read, the red indicator will continue flashing. While after reading successfully it will display, chip ID and the green indicator will keep flashing. At this time it is ready to copy, take out the chip and substitute the special chip for Magic WAND, press “Write” button and complete copying, after that it will display chip ID ,at the same time the green indicator will continue flashing, if it fails to copy, the red indicator will keep flashing.
Write ( This button is used to generate and copy chip)
Generate Chip: Put the chip into the slot , press the chip ID you want to generate, press “Write” button to get the results, the green indicator will keep flashing and display chip ID. In contrast, if the red indictor flashes it means reading is finished, maybe you put an error chip or the chip doesn’t match with the device.
Copy: you need to read out the chip ID before to copy, after it read out successfully you will get the chip ID, just press “Write” to finish copying. While if the red indicator flashes it means the chip doesn’t match with the device.
NOTES:when you add the key, you have to put the Magic Wand close to the ignition coil and the key go through the hole of Magic Wand, then follow the key programmer prompt to finish.
1.Put the original 4D70 blank chip into the chip slot.
2.Press the No. buttons 8 and 3, then press “Write” button, the green indicator will flash and means copy successfully.
3.Put the chip back into the key shell, then take it to the car to add key work together with key programmer.